Before You Add an EV Charger or Generator, Check Your Panel
An EV charger and a standby generator both put real demands on your electrical panel, and an older or full panel may not be able to carry either.

Generac Prestige DealerGenerac's highest dealer designation. We sell, install and service Generac home standby generators.
Generac generatorsBefore You Add an EV Charger or Generator, Check Your Panel
The main things to look at are the panel's amperage rating, how many open spaces it has, its age and brand, and how much your home already uses with the AC running. A Level 2 EV charger needs its own dedicated circuit, and it is a large continuous load. A generator needs a transfer switch tied into the panel.
If the panel is full, undersized or a known problem brand, an upgrade comes first. We measure the load and tell you plainly what is needed, and what is not.
What we look at
- The amp rating. It is usually printed on the main breaker at the top of the panel, and you can read it without opening anything. Never remove the panel cover yourself.
- Open spaces. A panel with every slot filled, or with breakers sharing a slot, leaves no clean way to add a circuit for a new load.
- Brand and age. Federal Pacific (often sold as Stab-Lok) and Zinsco panels are widely documented as having problems with some of their breakers. If you see one of those names, have it evaluated before anything is added.
- Condition. Rust, water stains, a hot cover, buzzing or burn marks need attention first.
- What the house already uses. We look at the load with the AC running, plus what you plan to add.
The generator side
A whole-home standby generator connects through a transfer switch, and the main service has to be compatible with it. Transfer switches are rated in amps, and the rating has to match the service it controls. A home with 200 amp service usually needs a 200 amp switch for whole house coverage. If we find a worn, full or problem panel, we tell you before anything is installed, and sometimes the panel upgrade belongs in the same project. See transfer switches and electrical panel upgrades.
The EV charger side
A home charger can use as much power as a large appliance, and it may run for hours. A Level 2 charger needs its own dedicated circuit. Whether the panel needs work first depends on your current load and the panel's capacity, which we check before installing. See EV charger installation.
Planning both, or adding one later
If you want a charger now and a generator later, or the other way around, say so on the first visit. The load calculation counts what you run now and what you plan to add. A charger also adds load to the generator during an outage, so it belongs in the generator sizing too. Our guide Do I need a 200 amp panel? explains how we decide.
Ask us anything. These come up most.
Do I need a bigger panel for an EV charger?
Sometimes. It depends on your current load and the panel's capacity, which we check before installing.
Should I upgrade the panel before adding a generator?
If the panel is full, old or undersized, yes. We check it on the free visit.
How do I find my panel's amp rating?
It is usually printed on the main breaker at the top of the panel, and you can read it without opening anything. Never remove the panel cover. If you are unsure, we confirm it on the free visit.
Can the panel upgrade and the generator be one project?
Yes. When the panel is worn, full or a problem brand, the upgrade often belongs in the same project as the transfer switch so the whole system is safe. It shows on the estimate as its own line with the reason.
My panel buzzes or feels hot. Should I still add a charger?
Not yet. A hot panel, buzzing or a burning smell needs attention first. Do not open it. Call us, and if you smell burning or see smoke, call emergency services first.
From first call to finished job.
Estimates are free. Call any time, day or night.
